Page 1 of 1

Raid5 Degraded shows corrupt

Posted: 02 Jul 2020 05:44
by imkiwi1
Hey everyone!

I'm looking for some help here on my system with a corrupt degraded RAID5. I have been running Nas4Free 9.x version for 6 years flawlessly. About a week ago I was writing some large files to it and shortly after it stopped booting into the OS. It was not getting to the console menu, just kept rebooting over and over. I discovered a bad power supply, replaced it and still had the same issue! I did briefly see this- "kernel: GEOM: ada0: corrupt or invalid GPT detected. kernel: GEOM: ada0: GPT rejected -- may not be recoverable" in the boot up. I figured I had a corrupt drive on ada0 so removed the 1st SATA drive and rebooted. This time it booted all the way & I got into the gui. I went immediately to disk management and as expected ada0 showed missing. Then I decided to plug it back in. I wanted to see if it was in fact the culprit. It did reboot again & showed ada0 drive back in there only I now have a degraded RAID5. All drives show online & SMART shows ok. What is strange is ada0 does not show in RAID under Diagnostics|Information|Software RAID

[*]Geom name: Raid5
State: DEGRADED HOT
Status: Total=4, Online=3
Type: AUTOMATIC
Pending: (wqp 0 // 0)
Stripesize: 131072
MemUse: 52224 (msl 3)
Newest: 3
ID: 2551063837
Providers:
1. Name: raid5/Raid5
Mediasize: 9001778675712 (8.2T)
Sectorsize: 512
Mode: r1w1e2
Consumers:
1. Name: ada3
Mediasize: 3000592982016 (2.7T)
Sectorsize: 512
Stripesize: 4096
Stripeoffset: 0
Mode: r2w2e3
DiskNo: 0
Error: No
2. Name: ada2
Mediasize: 3000592982016 (2.7T)
Sectorsize: 512
Stripesize: 4096
Stripeoffset: 0
Mode: r2w2e3
DiskNo: 2
Error: No
3. Name: ada1
Mediasize: 3000592982016 (2.7T)
Sectorsize: 512
Stripesize: 4096
Stripeoffset: 0
Mode: r2w2e3
DiskNo: 1
Error: No

Any help would be greatly appreciated 6 years of photos and videos are in risk of been gone forever :(