Page 1 of 1

WebGUI service will not start

Posted: 01 Dec 2018 17:51
by ESKIMOn00b
(This was posted in Newbie Questions but was advised to ask here as well)

I have installed (full install) and configured XigmaNAS on a machine

After setting up the disks and such the way i wanted, i rebooted the system to check startup, everything booted fine.

Then i went to configure a jail (thebrig) to run SABnzbd, sonarr, radarr etc...

everything went smoothly and is all running properly.

when i reboot the system (with Jail configured to auto start on boot) the webgui will not load. I can connect via SSH just fine, also the Webgui for sabnzbd, sonarr, and radarr load just fine. attempting to restart lighttpd get the error of

Code: Select all

getaddrinfo failed:  hostname nor servname provided, or not known '\n192.168.0.21
ifconfig outputs:

Code: Select all

re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
        ether d0:27:88:02:1f:5c
        hwaddr d0:27:88:02:1f:5c
        inet netmask 0xffffff00 broadcast
        inet netmask 0xffffff00 broadcast
        media: Ethernet autoselect (1000baseT <full-duplex>)
        status: active
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
        inet6 ::1 prefixlen 128
        inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2
        inet netmask 0xff000000
        nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
        groups: lo
the is the ip (i think it was specifically\24 as that was how it was notated in the description below the input box) i assigned to the jail in thebrig configuration page so i am assuming i am having some conflict with this, but dont know what or how to fix it.

any help would be appreciated