We try to use XigmaNAS on HPE DL380 Gen10 with SmartArray P816i-a (via BHA mode).
During writing from network (via CIFS), after a few minutes there is an error put to the console, and any read from zpool hangs server.
Do you know if that can be hardware issues, or FreeBSD does not support Gen10 fully, or ZFS does not support it?
[ERROR]::[177:655.0][0.67.0][CPU 10][pqi_map_request]:bus_dmamap_load_ccb failed = 36 count = 131072
[WARN]:[177:655.0][CPU 10][pqisrc_to_start]:In progress on 67
No hardware RAID is defined, Smartarray is in midex mode, disks are visible in HBA mode to the system.
Either pool or dataset is made available to external backup system as SMB/CIFS storage.
ZPOOL is created and there are no hardware errors visible in ILO etc.
There are no errors in hardware noticed during extensive tests.
XigmaNAS version used: 18.104.22.168 - Ingva (revision 7091)
Result of command:
Code: Select all
# zpool status -v Pool_1 pool: Pool_1 state: ONLINE status: Some supported features are not enabled on the pool. The pool can still be used, but some features are unavailable. action: Enable all features using 'zpool upgrade'. Once this is done, the pool may no longer be accessible by software that does not support the features. See zpool-features(7) for details. scan: resilvered 1.02G in 0 days 00:00:09 with 0 errors on Wed Jan 8 13:58:47 2020 config: NAME STATE READ WRITE CKSUM Pool_1 ONLINE 0 0 0 raidz3-0 ONLINE 0 0 0 da0p1 ONLINE 0 0 0 da1p1 ONLINE 0 0 0 da2p1 ONLINE 0 0 0 da3p1 ONLINE 0 0 0 da4p1 ONLINE 0 0 0 da5p1 ONLINE 0 0 0 da6p1 ONLINE 0 0 0 da7p1 ONLINE 0 0 0