HI All,
I tried installing NAS4FREE build 975 ..
System config:
1. Intel server board S1200BTS Motherboard, BIOS Version - 020041
2. Intel Xeon E3-1220v2 processor -
3. 16Gb DDR3 ECC Reg. RAM - 8.0 Gb x 2
4. 1.0TB x 4 nos. of Seagate Enterprise SATA Hard Disk Drive. - model no. ST1000NM0033
During install process I get AHCI errors
cam status : ATA status error
syschronise cache failed
removing device entry
Also, when I tried to install on atom dual core processor, it does not even show the hard drives to install...
Any idea, suggestions?
Thank you.
/vachu
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
AHCI Error
-
apollo567
- Site Admin
- Posts: 675
- Joined: 23 Jun 2012 06:37
- Location: Ludwigshafen, Germany
- Status: Offline
Re: AHCI Error
Well try the official version 972 and use an embedded install.
Check hardware Compatibility list of FreeBSD 9.2 for your hardware.
Check hardware Compatibility list of FreeBSD 9.2 for your hardware.
my NAS and its development until today: viewtopic.php?f=63&t=39&sid=039fed830cf ... 4d0abe4a04
-
b0ssman
- Forum Moderator
- Posts: 2438
- Joined: 14 Feb 2013 08:34
- Location: Munich, Germany
- Status: Offline
Re: AHCI Error
Please post the entire dmesg output in both cases.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Nas4Free 11.1.0.4.4517. Supermicro X10SLL-F, 16gb ECC, i3 4130, IBM M1015 with IT firmware. 4x 3tb WD Red, 4x 2TB Samsung F4, both GEOM AES 256 encrypted.