Page 1 of 1
Keboard freeze not able to install
Posted: 18 Jun 2014 10:08
by fiorenzi
Hi,
I am new of free4nas, I have make e usb bootable key with image for installation.
when I boot al works fine, led of CapLock f usb keyboard (HP & Dell) are ok, after first screen of booting led of keyboard go off and when I arrive to che configuration screeen, choose network etc.. I have no response form my keyboard.
I have changed on bios usb supporto disabling legacy mode but is the same.
is there I can do, parameter to se during booting?
Thanks
Alessandro Fiorenzi
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 10:35
by crowi
Can you give more information of your hardware, mainboard, processor, RAM, etc?
Did you plug your keyboard on USB3 port??
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 10:50
by b0ssman
do you mean nas4free or freenas?
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 11:21
by fiorenzi
Well, motherborad is MSI H87-G14 PC MATE, RAM 16 GB HD 6 SATA Seagate 3TB
Keyboard is plugget on standard usb, not usb 3 (blu connector)
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 11:22
by fiorenzi
I am trying to install Nas4Free, sure.
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 11:43
by crowi
There were some other USB errors reportet with NAS4free 9.2.x.x. try 9.1.x.x.
Btw, your board does not support ECC RAM, so don't use ZFS.
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 12:00
by fiorenzi
Ok, I will try as you suggest.
but why not to use ZFS with no ECC RAM? a memory corruption is not the same for zfs and other filesystems?
I was thinking about install nas4free on usb key 16 GB and use all 6 drivers settings raid 10, any tips for a newbie?
wich file system you suggesto to use?
Thanks very much, your suggestions are very helpful
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 12:19
by crowi
but why not to use ZFS with no ECC RAM? a memory corruption is not the same for zfs and other filesystems?
It is different in ZFS, please read:
http://forums.freenas.org/index.php?thr ... zfs.15449/
wich file system you suggesto to use?
You can go with UFS and Software RAID e.g. RAID 5 or RAID 10 whatever you want. Just RAID 6 is not supported in N4F.
Re: Keboard freeze not able to install
Posted: 18 Jun 2014 14:09
by armandh
all 3 of mine are non ECC and ZFS.
they are without problem;
I think.
with ECC I would know!
my backup is rotated across the 3 redundant NAS
I had the spare hardware then, but...
If I was buying new hardware today it would be ECC
I have never had a problem with any of these 3 NAS
but this hardware would never get through a day of mem-test
https://www.youtube.com/watch?v=bcfeRPWCBWM
I did not keep it even though it appears to work fine.