Newbie,
I setup a nas4free server about 18 months ago and it crashed today. After repeated tries it doesn't finish the boot up process. When I boot the server in verbose mode it just repeats the following message:
acpi_tz0: _AC4: temperature 27.8 >= setpoint 0.0
acpi_tz0: _AC3: temperature 27.8 >= setpoint 0.0
..
..
I have no idea what to look for. I searched on the internet but the few hits that I found were all beyond my experience.
Any info or advice would be greatly appreciated!
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
ACPI Error
-
apollo567
- Site Admin
- Posts: 675
- Joined: 23 Jun 2012 06:37
- Location: Ludwigshafen, Germany
- Status: Offline
Re: ACPI Error
Some questions first :
Which N4F version do you use ?
Do you use ZFS or Softraid ?
Do you have a (actual) copy of config.xml ?
Regards
apollo
Which N4F version do you use ?
Do you use ZFS or Softraid ?
Do you have a (actual) copy of config.xml ?
Regards
apollo
my NAS and its development until today: viewtopic.php?f=63&t=39&sid=039fed830cf ... 4d0abe4a04