XigmaNAS

Hi, ALL
Using ARM (Raspberry pi v2) with an installed image NAS4Free-rpi2-SD-2015-11-08 10.2.0.2.2003.img 1.5 GB.
After uploading the image and after a few configuration steps NAS4Free after the restart I get the message Warning: no time-of-day clock registered .... "and the system is waiting for ...?
Is this a mistake? which will improve so much that one could continue to run the system? It's fun juak kortzystamy the LAN to the Internet and as for the network with no access to the internet? - Stops and does not intend to go further - I waited more than 24 hours and nothing.
I do not know whether this is due to the configuration and can applied solutions !? Using the mini SD card problem occurred 16GB and 32GB card is for

Auto Google Translation

Witam, ALL
Korzystam z ARM (Raspberry pi v2) z zainstalowanym obrazem NAS4Free-rpi2-SD-10.2.0.2.2003.img 2015-11-08 1.5 GB.
Po wgraniu obrazu i po kilu krokach konfiguracji NAS4Free po restarcie otrzymuje komunikat Warning: no time-of day clock registered ...." i system stoi i czeka na ...?
Czy to jest bład? który da sie tak poprawić aby dawało sie dalej uruchamiac system? Fajnie juak kortzystamy z sieci lan z internetem a co w przypadku sieci bez dostepu do internetu ? - Zatrzymuje sie i nie ma zamiaru isc dalej - czekalem ponad 24h i nic z tego.
Nie wiem czy wynika to z konfiguracji a moze zastosowanych rozwiązań!? wykorzystujac karte mini sd 16GB problem nie wystapil a dla karty 32GB jest

Auto tlumaczenie google

_Toem wrote:time-of-day clock registered .... "and the system is waiting for ...?
Is this a mistake?

"Warning: no time-of-day clock registered" is normal because RPI does not have RTC module(battery backuped clock) by default.
To adjust date/time, enable NTP on System|General Setup is workaround.

What is waiting??
"and the system is waiting" is probably you use DHCP?
If so, check your router is alive while RPI is staring. It will be checked by ping to the router.
(no need internet connection at boot time)
If hard to fix router, try to use static IP address.

Hello,
thanks for the reply, everything is good but still do next is up to date.
How do you explain a situation in which
Raspberry same, the same image IMG for free4nas
when I use the SD card 16G - the problem does not occur with the theme
when the card is 32G problem occurs after system reboot

Auto google translation

Witam,
dzieki za odpowiedź, wszystko fajnie ale jednak temat dalej jest aktualny.
Jak wyjaśnić sytuację w której
ten sam Raspberry, ten sam obraz IMG dla free4nas
gdy zastosuję kartę SD 16G - problem z tematu nie wystepuje
gdy jest karta 32G problem się pojawia po restarcie systemu

auto tłumaczenie google