This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!


I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!

How to restore detected pool

Forum rules
• Set-Up Guide • FAQs • Forum Rules
Post Reply
benardmens
NewUser
NewUser
Posts: 5
Joined: 30 Jun 2012 21:30
Status: Offline

How to restore detected pool

Post by benardmens »

Hi all,

I had a problem with my NAS4free install and re installed the OS. I read that I could do a zfs import which I went ahead and did. Now I can see the pool with all the data via the command line but its not showing up in the ZFS page on the web ui :o . Not sure how to proceed from here. I think because its not showing up through the UI I cant share anything from the zpool either.

Any help is appreciated
Top
benardmens
NewUser
NewUser
Posts: 5
Joined: 30 Jun 2012 21:30
Status: Offline

Re: How to restore detected pool

Post by benardmens »

resolved my issue following this link http://www.forums.nas4free.org/viewtopi ... =66&t=5351
Top
Post Reply

Return to “ZFS (only!)”