Hi,
I have 3 disk in right now and want to format only 1 drive in ZFS (ada3) and the rest is in UFS . I created a virtual drive with ada3 (stripe), and then I try to manage to create a pool but it gives me a error code 1 when i try to to save ??
What do i do....
Jeff
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
ZFS problem
-
kenZ71
- Advanced User
- Posts: 379
- Joined: 27 Jun 2012 20:18
- Location: Northeast, USA
- Status: Offline
Re: ZFS problem
Error code 1 is the most un-helpful error.
Why would you want a mixed setup ? ZFS is much better. Any chance you could go all in with ZFS ?
Why would you want a mixed setup ? ZFS is much better. Any chance you could go all in with ZFS ?
11.2-RELEASE-p3 | ZFS Mirror - 2 x 8TB WD Red | 28GB ECC Ram
HP ML10v2 x64-embedded on Intel(R) Core(TM) i3-4150 CPU @ 3.50GHz
Extra memory so I can host a couple VMs
1) Unifi Controller on Ubuntu
2) Librenms on Ubuntu
HP ML10v2 x64-embedded on Intel(R) Core(TM) i3-4150 CPU @ 3.50GHz
Extra memory so I can host a couple VMs
1) Unifi Controller on Ubuntu
2) Librenms on Ubuntu
-
b0ssman
- Forum Moderator
- Posts: 2438
- Joined: 14 Feb 2013 08:34
- Location: Munich, Germany
- Status: Offline
Re: ZFS problem
if you go with zfs put it on all the drives.
you can try to create it from the console.
you can try to create it from the console.
Nas4Free 11.1.0.4.4517. Supermicro X10SLL-F, 16gb ECC, i3 4130, IBM M1015 with IT firmware. 4x 3tb WD Red, 4x 2TB Samsung F4, both GEOM AES 256 encrypted.