Hi Guys,
im running ZFS RaidZ1 on 5 2TB HDDs, in a Hp Microserver N40L,
Last night i got an email saying that one of my HDDs was missing, i turned the server off(Not Hot Swappable) and had a look at the missing HDD(funny enough it wasn't missing it was right there....) and confirmed which one was missing.
I then decided to plug the HDD back in and restart the server.
The server now says that the POOL is Healthy and all the HDDs are ONLINE.
The server may have been working with only 4 HDDs for half a day to a day,
My question is, How can i tell that the Raidz1 pool is fully synchronized and make sure that it is running with all 5 drives perfectly?
Thanks,
Dan
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Missing Disk
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: Missing Disk
go to ZFS webGUI and do a ZFS Scrub, when done, your zpool must be clean, (Or use Zpool clear) to delete warnnings.
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510