Hi Guys,
I replaced a faulty drive last night in my Microserver n40l.
once i had the drive in and rebooted the system i followed the instructions from this website:
http://www.bolsondigital.com/2013/06/01 ... -nas4free/
to add the hdd back into my zpool.
after doing this the hdd re-silvered and was added back into the pool. However for some reason i am still getting a warning message even tho everything states that it is healthy and online. I have attached the pictures below, could someone help me with what i need to do to fix this.
regards,
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Replaced HDD
-
DanAddz
- Starter
- Posts: 63
- Joined: 23 Dec 2012 06:32
- Status: Offline
Replaced HDD
You do not have the required permissions to view the files attached to this post.
-
RedAntz
- experienced User
- Posts: 125
- Joined: 11 Jul 2012 07:46
- Location: Sydney, Australia
- Status: Offline
Re: Replaced HDD
You replace a new drive to the system, but NAS4Free's config is not updated with the new drive information yet.
That is why it is complaining that there is a mismatch between the actual hardisks and hardisks 'known' in config.
Did you do 'clear and import' as suggested ?
That is why it is complaining that there is a mismatch between the actual hardisks and hardisks 'known' in config.
Did you do 'clear and import' as suggested ?
-
DanAddz
- Starter
- Posts: 63
- Joined: 23 Dec 2012 06:32
- Status: Offline
Re: Replaced HDD
Hi RedAntz,
i didnt clear and import, i no this sounds noobish but, i dont know how to do that haha.
Could you give me a quick run down on how to do it and what it does?
regards,
i didnt clear and import, i no this sounds noobish but, i dont know how to do that haha.
Could you give me a quick run down on how to do it and what it does?
regards,
-
RedAntz
- experienced User
- Posts: 125
- Joined: 11 Jul 2012 07:46
- Location: Sydney, Australia
- Status: Offline
Re: Replaced HDD
There is a button called 'Clear and Import' on Disks|Management page. Clicking it tells NAS4Free to clear all disks in config and re-import what it detects in your system.