XigmaNAS

Hi Guys,

I replaced a faulty drive last night in my Microserver n40l.

once i had the drive in and rebooted the system i followed the instructions from this website:

http://www.bolsondigital.com/2013/06/01 ... -nas4free/

to add the hdd back into my zpool.

after doing this the hdd re-silvered and was added back into the pool. However for some reason i am still getting a warning message even tho everything states that it is healthy and online. I have attached the pictures below, could someone help me with what i need to do to fix this.

regards,

You replace a new drive to the system, but NAS4Free's config is not updated with the new drive information yet.
That is why it is complaining that there is a mismatch between the actual hardisks and hardisks 'known' in config.

Did you do 'clear and import' as suggested ?

Hi RedAntz,

i didnt clear and import, i no this sounds noobish but, i dont know how to do that haha.

Could you give me a quick run down on how to do it and what it does?

regards,

There is a button called 'Clear and Import' on Disks|Management page. Clicking it tells NAS4Free to clear all disks in config and re-import what it detects in your system.