I've removed the failed disk and replaced it with a good drive and that is seen in disk management
but If I run a status on the ZFS pool, the replacement doesn't show up... so I'm not sure how to replace it?
Can anyone help? I'm desperate
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Problems with replacing drive
-
cls33
- NewUser
- Posts: 8
- Joined: 09 Jun 2014 23:13
- Status: Offline
Problems with replacing drive
I had a drive in my ZFS pool fail. I replaced several failed drives when my pool was managed via open solaris, but I've since imported it into NAS4Free and I'm having issues getting the replacement disk to be seen by the ZFS pool.
I've removed the failed disk and replaced it with a good drive and that is seen in disk management
but If I run a status on the ZFS pool, the replacement doesn't show up... so I'm not sure how to replace it?
Can anyone help? I'm desperate
I've removed the failed disk and replaced it with a good drive and that is seen in disk management
but If I run a status on the ZFS pool, the replacement doesn't show up... so I'm not sure how to replace it?
Can anyone help? I'm desperate
-
b0ssman
- Forum Moderator
- Posts: 2438
- Joined: 14 Feb 2013 08:34
- Location: Munich, Germany
- Status: Offline
Re: Problems with replacing drive
Nas4Free 11.1.0.4.4517. Supermicro X10SLL-F, 16gb ECC, i3 4130, IBM M1015 with IT firmware. 4x 3tb WD Red, 4x 2TB Samsung F4, both GEOM AES 256 encrypted.