Hey all,
I recently decided to delete my RAID-Z2 pool and virtual device, volume, share, etc. I have rebooted. All those tabs are empty under disks-ZFS, except that under configuration the pool and virtual device are still there (I use the GUI). How can I clean this up? Even on the the system status page it shows it as online. All other portions of the ZFS management area show no pools, datasets. virtual devices or volumes.
thanks!
This is version 9.3.0.2 - Nayla (revision 1771)
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
ZFS Configuration active after deletion
-
bc2112
- NewUser
- Posts: 5
- Joined: 02 Nov 2015 02:06
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: ZFS Configuration active after deletion
Do you use WebGUI to delete pool?.
Please say step by step what you do.
Please say step by step what you do.
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
bc2112
- NewUser
- Posts: 5
- Joined: 02 Nov 2015 02:06
- Status: Offline
Re: ZFS Configuration active after deletion
Yes I did use the GUI....but when I updated the firmware to the latest V10, it fixed it. Does a gui deletion not work?