Any chance of adding a check box to enable/disable command scripts in the GUI? There are times I need to disable one or more temporarily.
Thanks
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Command Scripts enable/disable
-
bgold
- Starter
- Posts: 41
- Joined: 23 May 2015 08:42
- Status: Offline
Command Scripts enable/disable
XigmaNAS 12.0.0.4.6625
HP ML150 Gen9, Dual 2.4ghz, 256gb, 25TB Storage, 3-ZFS pools w/SSD cache&logs, SSD boot/data, SFP+
HP ML150 Gen9, Dual 2.4ghz, 256gb, 25TB Storage, 3-ZFS pools w/SSD cache&logs, SSD boot/data, SFP+
-
tonyd
- Starter
- Posts: 24
- Joined: 01 Nov 2012 16:20
- Status: Offline
-
jamaroney
- Advanced User
- Posts: 245
- Joined: 13 Aug 2012 17:32
- Location: Stroudsburg, PA
- Status: Offline
Re: Command Scripts enable/disable
Yes!
It would also be great if new commands could be inserted anywhere in the sequence. Right now, if I wish to post a new command any place other than last, I have to add it as desired into the config.xml file and restore N4F with that changed file.
It would also be great if new commands could be inserted anywhere in the sequence. Right now, if I wish to post a new command any place other than last, I have to add it as desired into the config.xml file and restore N4F with that changed file.