When switching from FreeNAS to NAS4Free I did "zpool export my-pool-name" in FreeNAS and then "zpool import my-pool-name" in NAS4Free terminal.
My pool appeared on filesystem but not in UI, this is obviously a bug/feature request. Is there any way to sync since I _obviously_ cannot add a new pool in UI with same name?
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
GUI is not in sync with ZFS changes
-
hopee
- NewUser
- Posts: 2
- Joined: 28 Aug 2012 22:34
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: GUI is not in sync with ZFS changes
yes go to Disks|ZFS|Configuration|Synchronize and push the syncrhonize button
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
hopee
- NewUser
- Posts: 2
- Joined: 28 Aug 2012 22:34
- Status: Offline
Re: GUI is not in sync with ZFS changes
Thanks. I need to take a closer look at the UI. 