Hello all,
I set up rsync today to back up my data to a QNAP device. All seems to be going well, at least the files are replicating. However, during my test run, I noticed when the rsync is running, the webui is completely unresponsive. When I click on a menu option (to check logs for example), the web page just sits as the loading indicator just spins.
I recently resilvered my ZFS pool, and while the resilver was running I could still navigate the N4F webUI with no problems. I would assume this is not the desired behavior. Have I set something up incorrect?
Any help is appreciated.
thanx
--nixIT
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
[SOLVED] WebUI unresponsive during rsync
-
nixIT
- Starter
- Posts: 29
- Joined: 01 Jun 2015 05:31
- Status: Offline
[SOLVED] WebUI unresponsive during rsync
Last edited by nixIT on 12 Jul 2016 21:09, edited 1 time in total.
-
spy0r
- Advanced User
- Posts: 160
- Joined: 18 Jun 2015 12:24
- Location: Munich, Germany
- Status: Offline
Re: WebUI unresponsive during rsync
did you start that rsync via web interface? if yes, i think this is a normal behavour... if you started via cronjob or via ssh, that shouldn't affect the gui.
NAS4Free 11.0.0.4 x64-embedded - Lian Li Q25b - AsRock Rack C2550D4I - 4x8Gb ECC Ram - 128Gb SSD Swap/Log/Extensions - RaidZ1: 3x3Tb Western Digital Red (WD30EFRX) - Backup: 1x8Tb Seagate Archive (ST8000AS0002) - APC Back UPS PRO (550VA)
-
nixIT
- Starter
- Posts: 29
- Joined: 01 Jun 2015 05:31
- Status: Offline
Re: WebUI unresponsive during rsync
@spy0r,
Thanx, I did start it through the web interface. I'm running some tests to make sure everything works before setting it up as a cron job. I will mark this as solved.
--nixIT
Thanx, I did start it through the web interface. I'm running some tests to make sure everything works before setting it up as a cron job. I will mark this as solved.
--nixIT