Dear all!
I'm newbie in installing and tuning NAS4Free and FreeBSD at all.
So I've got Intel SS4200-e (RAM 2GB, CPU Celeron 450, 1*8Gb IDE DOM with installed Full NAS4Free-x868-10.3.0.3.2898, 4*2TB SATA HDD with softraid (0+1)).
The original EMC software contains tool for tuning led panel lights (brightness, colour, events).
Is it possible to realize the same led control (i.e.from shell) in NAS4Free?
Some information about led control below. But I can't understand are any possibilities to use "linux drivers" in FreeBSD OS (I remember that FreeBSD is not Linux)?
http://ss4200.pbworks.com/w/page/5122751/FrontPage
Thanks!
p.s. Sorry for any mistakes, English is not my native language.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
How to install drivers for led panel
-
Pashtet
- NewUser
- Posts: 4
- Joined: 27 Jun 2016 10:12
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: How to install drivers for led panel
Please have a look at te LCDProc Forum
Is a generic driver/WebGUI for tons of different hardware so perhaps yours is supported:
viewforum.php?f=51
viewtopic.php?f=51&t=5603
Is a generic driver/WebGUI for tons of different hardware so perhaps yours is supported:
viewforum.php?f=51
viewtopic.php?f=51&t=5603
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
Pashtet
- NewUser
- Posts: 4
- Joined: 27 Jun 2016 10:12
- Status: Offline
Re: How to install drivers for led panel
Dear Raulfg3.
Thx for your feedback.
This is not led screen. It's a combination of 5-6 separated leds (like front panel of any pc case). But exists Linux driver that can manage this panel through gpio.
Are any ideas how to move this driver from Linux into FreeBSD?
Thx for your feedback.
This is not led screen. It's a combination of 5-6 separated leds (like front panel of any pc case). But exists Linux driver that can manage this panel through gpio.
Are any ideas how to move this driver from Linux into FreeBSD?