The problem of wake-on-lan wol and HP Microserver g7 on v11.x.x.x

[Barracuda]

Good day!
I have the NP Microserver G7 N40 with nas4free ver.10.3.0.3 (different builds, including 9.x.x.X)
Server remotely turns on from PC
On the tab
Network | LAN Settings
there is a wake on lan. It should be ON

nas-06: ~# ifconfig
bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=c219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,WOL_MAGIC,VLAN_HWTSO,LINKSTATE>
ether a0:b3:cc:e3:f4:8c
inet 192.168.20.106 netmask 0xffffff00 broadcast 192.168.20.255 
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
inet6 ::1 prefixlen 128 
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 
inet 127.0.0.1 netmask 0xff000000 
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
nas-06: ~# 

And when an upgrade on v11.x.x.x (different builds), this tab disappears. No it, and with a clean installation.
I understand - a problem with the adapter driver.
What to do?
Thank you!

Welcome to NAS4Free!
nas-06: ~# ifconfig
bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=c019b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,VLAN_HWTSO,LINKSTATE>
ether a0:b3:cc:e3:f4:8c
inet 192.168.20.106 netmask 0xffffff00 broadcast 192.168.20.255 
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
inet6 ::1 prefixlen 128 
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 
inet 127.0.0.1 netmask 0xff000000 
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
groups: lo 
nas-06: ~#

[ChriZathens]

Hello!
AFAIK, the patch for WOL has not been applied to the 11 series driver.