Hi Fellow Nas4Freers,
I'm experimenting with a setup where I boot from USB but use a harddrive (SAS) for handling Nas4Free swap (not to be confused with ZIL or CACHE for Pools)
During the install process the installer asks for how much swap should be provisioned, but I can't figure out how to assign where it will provisioned. Is this possible during the install process, or do I need to "redirect" and (possibly) resize after install?
Thank you
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
[SOLVED] Setting swap on non-boot disk/device
-
hailthemelody
- Starter
- Posts: 38
- Joined: 26 Feb 2017 15:03
- Status: Offline
[SOLVED] Setting swap on non-boot disk/device
Last edited by hailthemelody on 07 Mar 2017 07:29, edited 1 time in total.
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: Setting swap on non-boot disk/device
You need to configure before install, from webGUI:
You do not have the required permissions to view the files attached to this post.
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
hailthemelody
- Starter
- Posts: 38
- Joined: 26 Feb 2017 15:03
- Status: Offline
Re: Setting swap on non-boot disk/device
Thank you, I hadn't considered that before.