I have two NAS4FREE nodes configured for HAST and ZFS one works and shows ONLINE under Disks > Management > HDD Management, the other fails to read the disks and says MISSING shown here: http://prntscr.com/eknsbs
It also shows Device not found here: http://prntscr.com/eko59w
Why are my disks reported missing i don't know, both nodes are exactly the same and the HDD's are blinking and functioning fine. I tried importing with clear configuration, rebooting and formating the drives none worked. Both nodes have the same firmware for the controllers....
Please advise what does MISSING mean?
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
disks status = MISSING
-
SpaceOwl
- NewUser
- Posts: 3
- Joined: 16 Mar 2017 12:57
- Status: Offline
Re: disks status = MISSING
Reinstalled nas4free solved it......... now my ZFS pool import isnt working....
-
hailthemelody
- Starter
- Posts: 38
- Joined: 26 Feb 2017 15:03
- Status: Offline
Re: disks status = MISSING
Have you tried synchronizing the config?
https://www.nas4free.org/wiki/documenta ... ynchronize
https://www.nas4free.org/wiki/documenta ... ynchronize
-
SpaceOwl
- NewUser
- Posts: 3
- Joined: 16 Mar 2017 12:57
- Status: Offline
Re: disks status = MISSING
Hi there hailtheme,
yes i have tried, unfortunately i think the problem is i can't import the ZFS pool from nas 1 to nas 2 because i don't know if how this works exactly. I need more specific instructions XD This is what it says, and it gives an error when i try to import it on nas 2: http://prntscr.com/el0aly
*Edit*
I remade the pool on NAS 2 now the disks are missing again XD and i initialized HAST... hmm
yes i have tried, unfortunately i think the problem is i can't import the ZFS pool from nas 1 to nas 2 because i don't know if how this works exactly. I need more specific instructions XD This is what it says, and it gives an error when i try to import it on nas 2: http://prntscr.com/el0aly
*Edit*
I remade the pool on NAS 2 now the disks are missing again XD and i initialized HAST... hmm