Hi all,
Not sure if I have done the wrong thing here however I have just completed a full install of N4F onto a CF card on a SATA adapter. Its the only boot device in the box and I am using 2TB drives on external USB for storage. I quickly discovered that my few 'custom settings' where being lost using the embeded install so have done a full install but chosen not to include swap. As there will be no other changes following the initial setup how likely is this config to impact on CF card longevity?
Any comments etc appreciated!
Thanks!
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Limit writes to CF on SATA adapter
-
cpcnw
- Starter
- Posts: 27
- Joined: 11 Sep 2012 19:37
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: Limit writes to CF on SATA adapter
Hello, I have 2 CF ,one to clone actual so if I update to a new version and somethings goes wrong I can put original and all works fine again.
I move my logs and database to data disk (/mnt/mypool/temp).
Please read how to do :
viewtopic.php?f=75&t=204&p=459
http://wiki.nas4free.org/doku.php?id=faq:0046
I move my logs and database to data disk (/mnt/mypool/temp).
Please read how to do :
viewtopic.php?f=75&t=204&p=459
http://wiki.nas4free.org/doku.php?id=faq:0046
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510