Hi
I have installed NAS4Free 11.0.0.4 (4383) on an old HP DC7700 with a Intel 82566DM Gigabit network chipset but NAS4Free will only connect to my network at 100Mb/s instead of 1Gb/s. I tried setting it manually to 1000BaseTX through the network configuration page but it immediatly disconnected. On restart the interface initially connected, returned three pings then disconnected. The network switch was showing that the LAN was disabled. The hardware works fine at 1Gb under Windows and Linux Mint without issue.
How do I go about getting the network connection running at full speed?
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!