Bridge Configure problem

[raymondbh]

I created bridge0 from the GUI and restarted.
I added bridge0 as interface OPT1 from the GUI and restarted.

No configure options for OPT1 on the GUI.
I go to console and choose option 1, choose bridge0 as OPT1
Run option 2 from the console, only the LAN interface "asks for" settings.
Restart
Still no OPT1 in the webGUI.
Still not possible to configure OPT1 in the Console...
What am I doing wrong here?

Update:
This is a Qlogic 10gig card with 2 ports. Can it be driver related?
Tried to set one port of the card (ql0) to OPT1 and restart, but no luck. OPT1 does not appear in the GUI so I can configure it (it is listed as OPT1 under interface managment).
Still no luck with the console. Try to run option1 setup re0 as LAN and ql0 as OPT1. Run option2: only the LAN interface gets set up by this.

Help! anyone?

[raulfg3]

Sorry not totally related to your problem, but perhaps can help:

https://www.nas4free.org/forums/viewtop ... dge#p81348

[raymondbh]

Sorry not totally related to your problem, but perhaps can help:

https://www.nas4free.org/forums/viewtop ... dge#p81348

Does not find this related to my problem unfortunately...