NAS4Free 11.1.0.4.5606 released (FreeBSD 11.1-RELEASE-P10)

[zoon01]

The NAS4Free Team is pleased to announce the release of version 11.1.0.4.5606 - Atomics

Download build 11.1.0.4.5606
Please Read always the readme_11.1 file

Service: CAM Target Layer.
Be aware this feature is still EXPERIMENTAL! Your feedback is welcome.

Changes after release 11.1.0.4.5579
===============================
- WebGUI code & framework improvements.
- Update translations.
- Upgrade istgt to 20180521.
- Upgrade devcpu-data to 1.70.
- Upgrade php to 7.2.6.
- Upgrade bash to 4.4 patch 23.
- Upgrade nano to 2.9.8.
- Upgrade syncthing to 0.14.48.

Note:
- Make a new backup of your system configuration and store this on safe location, the system config.xml could be upgraded!
- Clear your browser's cache to avoid display issues after upgrade when coming from older release.

Enjoy!

Regards,
The NAS4Free Team

[sleid]

Embedded version upgrade from 5591 work fine

thanks!

[Victek]

Updated from 5591 too, works fine with my settings.

Cheers!

[jasch]

Upgrade from 5591 via Webgui(Rootonzfs) works fine.

[opel70]

I'll chime in to state that I upgraded from 5403 without any issues as well.

[jasch]

Hi,

just want to share, with the upgrade i also switched my ISCSI from igst to ctl, and it rocks.
ZFS Vol (2x Samsung EVO 850 256GB STripe for testing) 10Gbe Intel X540 on Win10 client, and 10Gbe Intel X540 on Nas4free (via PCIE Passthrough from Proxmox).

Linear Read write, saturate Link.
4K not looking bad for non RDMA Setup.

[zoon01]

jasch

Thanks for this feedback!
,

[jasch]

Hi, with 5606 i have still the ZFS spindown isse.

I am using Spindown since a long time.
after 5403 build(fresh install), i am run in to a little "bug".
I have multiple Pools.
Drives are going in standby, but as soon something writes (only write(local, Samba,ISCSI), read is ok) to one Pool, all Pools wake up.(only ZFS Disk, UFS Disks are fine)

(at the moment i have two Nas4free, new and old)
On my old System this is not happening(build was 47xx something), now for testing this out, i also upgraded the old to 5403, now it has the same wrong behavior.

[biggsy]

jasch,

could you please outline the steps you took to switch from istgt to ctl?

Thanks

[jasch]

I have not used my old ZFS Vol, i copied my Data to spare Space and made a new ISCSI Setup, new ZFS Vol....(there a lot diff)
for example ctl is presenting ZFSVol Blocksize as physical, igst was 512b default....
if you mean the Steps for this, i can provide those.

[biggsy]

Thanks, jasch.

I was hoping you might have been able to switch from istgt to ctl via the GUI - or through the command line but still relatively easy.

I might experiment in a VM when I have some time.

[netware5]

Updated from 5403. No problems so far. Thanks to developers!