Hi,
I'm using the lates firmware and have (since using NAS4Free) the following problem: I start my NAS:
Sapphire Tech. IPC-AM3DD785G
AMD Athlon X2 260u
4GB DDR3
2x2TB Samsung HD204UI
and have only 100Mbit. Network is set to 1000TX Full-Duplex
After reconnecting the NAS to the switch I'm getting 1GBit @ ~95MBit/sec.
Why down't it work @ the Startup?
Regards
Mick
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
LAN at Startup 100Mbit - cable reconnect 1GBit
-
mick
- NewUser
- Posts: 4
- Joined: 28 Oct 2012 11:13
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: LAN at Startup 100Mbit - cable reconnect 1GBit
other times, can be a hardware problem (cable), please try other new cat5e or cat6 cable. if not work for you please try to force in Network|LAN Management |Advanced Configuration |media = 1000baseTX instead of autoselect
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
mick
- NewUser
- Posts: 4
- Joined: 28 Oct 2012 11:13
- Status: Offline
Re: LAN at Startup 100Mbit - cable reconnect 1GBit
mick wrote:Hi,
Network is set to 1000TX Full-Duplex
Another cable has been tested.raulfg3 wrote:if not work for you please try to force in Network|LAN Management |Advanced Configuration |media = 1000baseTX instead of autoselect
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: LAN at Startup 100Mbit - cable reconnect 1GBit
can be tested , and..... work?
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
mick
- NewUser
- Posts: 4
- Joined: 28 Oct 2012 11:13
- Status: Offline
Re: LAN at Startup 100Mbit - cable reconnect 1GBit
No it doesn't.