When I used FreeNAS 0.7 with multiple USB devices I would often have the problem of the devices names getting mixed up. I once had a RAID component mixed up with a regular disk. To say the least, that data was lost (thankfully it was just test data).
Upon trying NAS4Free today I noticed that same potential problem. I am wondering if the following instructions still apply to the latest release of NAS4Free and if it's possible to have NAS4Free do this be default out of the box:
http://www.unibia.com/unibianet/freebsd ... nas-legacy
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Use Disk Labels instead of Device Names
-
tuaris
- experienced User
- Posts: 85
- Joined: 19 Jul 2012 21:31
- Contact:
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: Use Disk Labels instead of Device Names
YES, still apply.tuaris wrote:I am wondering if the following instructions still apply to the latest release of NAS4Free
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510