Hi All
I have recently setup NAS4Free on my NAS Server, all seemed well until I selected Status/ Disks in order to view the disk temps. After selecting this everything freezes on the WebGUI and does not recover. I have to turn my NAS off and back on in order for it to work again. Has anybody else had this issue?
Thanks
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Server Crashes when selecting Disk Status
-
Craig3690
- NewUser
- Posts: 1
- Joined: 31 Dec 2012 10:24
- Status: Offline
-
shakky4711
- Advanced User
- Posts: 273
- Joined: 25 Jun 2012 08:27
- Status: Offline
Re: Server Crashes when selecting Disk Status
Hi,
When you run an embedded install on a USB thumbdrive I would recommend to save your config file, install NAS4Free on another thumbdrive, restore config and test.
Cheap usb thumbdrives or drives with some defective cells can show the strongest effects...
Hint, some users had problems because of crappy data stored in the browser cache, delete this temporary data from your browser befor you enter the web gui.
Shakky
No, never...Has anybody else had this issue?
When you run an embedded install on a USB thumbdrive I would recommend to save your config file, install NAS4Free on another thumbdrive, restore config and test.
Cheap usb thumbdrives or drives with some defective cells can show the strongest effects...
Hint, some users had problems because of crappy data stored in the browser cache, delete this temporary data from your browser befor you enter the web gui.
Shakky