Hi,
i just set up a nas4free VM to try and test a bit.
I initialized a storagepool, created a user with a homredirectory on that pool, enabled samba and created a share on the homedirectory of the created user.
I pretty much used standard settings for all of that.
But when i try to connect to the share from a win7 machine it doesnt work. i cant browse the nas4free shares though it is online and when i manually enter the path to the share and username + password it just keeps asking again.
can you give me any hints where the problem could be?
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Cant connect to samba
-
NemesisFS
- NewUser
- Posts: 2
- Joined: 26 Jan 2013 20:56
- Status: Offline
Re: Cant connect to samba
Using the IP i can now connect to the share...
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: Cant connect to samba
Read this post, perhaps help you : viewtopic.php?f=21&t=2980
If not , post the same information ( How do you have configured your SAMBA and your Shares)
If not , post the same information ( How do you have configured your SAMBA and your Shares)
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510