Aktual Nas4free build(selfmade)

[jasch]

Sorry maybe its the wrong forum, i just want to now if there is actual someone who can make a Nas4free from scratch with changes, i dont get it at the moment.
I can make an Image(lots of warning) its working, but i doesnt contain my changes is just like i had not added them.
Like all the Time be fore i just add

Code: Select all

options        OFED            # Infiniband protocol stack and support
options        SDP             # Sockets Direct Protocol for infiniband
options        IPOIB_CM        # Use connect mode ipoib

device         ipoib           # IP over IB devices
device         mlx4ib          # ConnectX Infiniband support
device         mlxen           # ConnectX Ethernet support
device         mthca           # Infinihost cards

to /usr/local/nas4free/svn/build/kernel-config /NAS4FREE-amd64

Its compiling and at the end the image has the same size like whitout and the drivers are not added.
And i have in the last cleaning all my old working builds deleted .

MFG Alex


Ok i got allround all the warning i useds direct SVN src and ports checkout, but not compiling ports breaks on lcdproc.
I disabled lcdproc and now all goes trough without Problems, but still no infiniband drivers.
Im confused.

[jasch]

Ok now its working last aproch did it, i was just confused since its was same imagesize again, but this was because of no lcdproc.
MFG Alex

So to round this up

U can use the wiki but u have to use svn instat of cvsup checkout.
The update source in make.sh is not working (asking for password...)
You have to manually copy fuppes or deselect.
lcdproc you have to deselect on build and install.

MFG Alex

Update after manually reinstalling phyton27 from ports lcdproc compile is now ok.