Hi,
I did a memory upgrade to my N40L and afterwards it's showing no disks configured. It's a ZFS pool and didn't change anything apart from the RAM, could someone point me in the right direction to bring the pool back up? I saw FAQ 00094 but as a newb I am not certain on the best way to bring it back.
Thanks heaps
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
No disk configured after memory upgrade
-
MadGadget
- NewUser
- Posts: 2
- Joined: 06 Apr 2013 05:48
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: No disk configured after memory upgrade
Go to Disks|Management and push new button " Clear Config & Import Disk" next go to Disks|ZFS|Configuration|Detected and import detected pool ( push button twice if first time do a error.
then go to Disks|ZFS|Configuration|Synchronize and sync your config to webGui to reflect changes.
thats all...
then go to Disks|ZFS|Configuration|Synchronize and sync your config to webGui to reflect changes.
thats all...
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
MadGadget
- NewUser
- Posts: 2
- Joined: 06 Apr 2013 05:48
- Status: Offline
Re: No disk configured after memory upgrade
Fantastic, can see the pool now in the GUI.
Many thanks
Many thanks