Hello,
I am currently using the embedded version running from a USB drive, but it's limitations are becoming a burden. Is there a simple way to upgrade or replace to the full version without losing all of my configurations?
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Embedded to full
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: Embedded to full
Yes, simply save your actual config, do a new full install ( in a proper boot device), and once reboot and boot fine , restore previosly saved config.
PD: Proper boot device, can be a USB key , but you need to move logs to data disk to avoid write problems, and it's better to use an old IDE disk or some kind of profesional USB/CF disk to avoid write/exhaust/burn problems.
PD: Proper boot device, can be a USB key , but you need to move logs to data disk to avoid write problems, and it's better to use an old IDE disk or some kind of profesional USB/CF disk to avoid write/exhaust/burn problems.
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510