This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
NAT support
-
Babovand
- Starter
- Posts: 46
- Joined: 23 Jun 2012 16:25
- Status: Offline
NAT support
Please add support for NAT in the firewall/Kernel. I've an OpenVPN server and I've my own reasons to tunnel all traffic from the clients to the VPN server, since there is no NAT the OpenVPN server cannot access the internet, only services on my local LAN that is connected to the router.
Last edited by Babovand on 24 Apr 2013 21:43, edited 2 times in total.
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: NAT support
+1 , I do not find any good reason because is not still included.
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
Babovand
- Starter
- Posts: 46
- Joined: 23 Jun 2012 16:25
- Status: Offline
Re: NAT support
Exactly, I would have added support for it myself but I am unable to compile the kernel, always some errorraulfg3 wrote:+1 , I do not find any good reason because is not still included.
I am guessing that it wouldn't make Nas4Free bloated or "bigger" in size, and from what i read it only a couple of lines to add NAT support in the kernel/firewall.
Hope developers see this, and thanks.