The Syba HyperDuo SD-PEX40054 is a PCI-e x2 4 port SATA III card using the Marvell 88SE9230 chipset. This is a later chipset commonly found on the better motherboards commonly recommended here. It can also be found quite cheaply.
I had a SATA card go out, and this was available locally. Pluged directly in, and it half height capable. Working well on a 12 drive ZFS system. However, it does NOT support port replicators.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Another working card - Syba HyperDuo SD-PEX40054
-
Lee Sharp
- Advanced User
- Posts: 251
- Joined: 13 May 2013 21:12
- Contact:
- Status: Offline
-
b0ssman
- Forum Moderator
- Posts: 2438
- Joined: 14 Feb 2013 08:34
- Location: Munich, Germany
- Status: Offline
Re: Another working card - Syba HyperDuo SD-PEX40054
does it support spindown via camcontrol?
Nas4Free 11.1.0.4.4517. Supermicro X10SLL-F, 16gb ECC, i3 4130, IBM M1015 with IT firmware. 4x 3tb WD Red, 4x 2TB Samsung F4, both GEOM AES 256 encrypted.
-
Lee Sharp
- Advanced User
- Posts: 251
- Joined: 13 May 2013 21:12
- Contact:
- Status: Offline
Re: Another working card - Syba HyperDuo SD-PEX40054
I have not tested that, as it is not needed for this install. But it is a standard chipset used in many motherboards, so I suspect it does.