Hi
it might sound stupid, but i am a bit worried to lose data.
I opend my freenas box ( running the old freenas 0.7) and disconnectet (by accident) one drive that was just a single UTF drive in the configuration (not part of any raid)
Now after reconnecting it it's not accessable:
in Disk managemant it says: "ad8 missing"
in mountpoint it says : /dev/ad8p1 error retry
So what to do to get the drive and data back in the system?
should i deletethe mountpoint or should i delete the disk? what does "delete disk" actually do? does it kill all data or just takes the formatet disk out of the configuration so i could get it back into it afterwards?
Best
Robert
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
remount disk after disconnection (disk missing)
-
paulchen25
- Starter
- Posts: 15
- Joined: 10 Nov 2013 15:17
- Status: Offline
-
paulchen25
- Starter
- Posts: 15
- Joined: 10 Nov 2013 15:17
- Status: Offline
Re: remount disk after disconnection (disk missing)
I the end i worked it out.
It was not a configuration problem or anything to do with freenas.
but the sata cabel was still disconnectet even it looked perfecty. Hardware failure.
best
r
It was not a configuration problem or anything to do with freenas.
but the sata cabel was still disconnectet even it looked perfecty. Hardware failure.
best
r