[Solved]NAS has no connection to router

[Morrio]

Hi all,

I installed N4F yesterday on my (first) NAS. Installation was ok as far as I know.
But after I configure the network IP Adress (DHCP Yes - IPv6 No) I get the IP Adress 127.0.0.1 for the WebGui and that can't be right.
Also i can not see the NAS in the DHCP Clients in the Router Configurations. Until now i never had a problem to get an ip with other PCs, Notebooks,...
It is also not possible to ping the router (From NAS).

Hopefully someone has an idea.

[armandh]

step #1 is to enable the NIC card or chip then step #2 [IP address]
be sure that you are connected to a known good router that will supply the DHCP address

[Morrio]

Hi,

in step 1 ist only "auto-detection" possible to select.
At least the message "No link-up" detected is shown

[Morrio]

Hi,

i have the Asus H87i-Plus, and it looks like N4F did not support this board at the moment?

[armandh]

if there is a spare slot, a supported Gb NIC is the way to go

the OS will run on most any 32 or 64 bit [64 is way faster]
ZFS works well in the faster end of equipment range
I have tested both ends of the range, extreme light end shown here
http://www.youtube.com/watch?v=NT0VTwr_ ... e=youtu.be

[raulfg3]

Hi,

i have the Asus H87i-Plus, and it looks like N4F did not support this board at the moment?

Correct, use intel i217, that is supported by BSD 9.2 that is comming soon, try this experimental build to test: viewtopic.php?f=17&t=5608

[Morrio]

Thanks 9.2 works!!!

Is there already known a release date for this version?

[raulfg3]

as soon as as tested by users like you.

Please contribute, and post problems/bugs that you detect.