Hi,
I create raid 0+1 volumn use HP P400 sas controller (2x channels) Pci-eX4 512Mb with 2TB x 4 Hard Disk,
sometime system logs show ("naserver kernel: ciss0: *** Inconsistent stripe, LDrv=0 LBA=0x13CA24A00-0x13CA24BFF")
Anyone can help me to fix this error, thx.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
HP P400 SAS Pci-eX4 512Mb with raid 0+1 Ufs
-
aviator01
- NewUser
- Posts: 2
- Joined: 30 Jan 2014 01:44
- Status: Offline
-
b0ssman
- Forum Moderator
- Posts: 2438
- Joined: 14 Feb 2013 08:34
- Location: Munich, Germany
- Status: Offline
Re: HP P400 SAS Pci-eX4 512Mb with raid 0+1 Ufs
the HP P400 have terrible performance.
if you have 4 sata ports on your mainboard i would suggest that u use them to create a zfs setup.
if you have 4 sata ports on your mainboard i would suggest that u use them to create a zfs setup.
Nas4Free 11.1.0.4.4517. Supermicro X10SLL-F, 16gb ECC, i3 4130, IBM M1015 with IT firmware. 4x 3tb WD Red, 4x 2TB Samsung F4, both GEOM AES 256 encrypted.