Hi,
I noticed there is an embedded image file on sourceforge. Is it possible to skip downloading the liveCD and just write the embedded image file to a USB stick? If it is, are there some instructions (for Windows or OS-X) on how to do this somewhere?
Thanks.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
How do I install the embedded image to a USB?
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: How do I install the embedded image to a USB?
YES, read faq 37: http://wiki.nas4free.org/doku.php?id=faq:0037
Or knowledgeBase 296 : http://www.freenaskb.info/kb/?View=entry&EntryID=296
Or knowledgeBase 296 : http://www.freenaskb.info/kb/?View=entry&EntryID=296
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510
-
bluepill
- Status: Offline
Re: How do I install the embedded image to a USB?
Thanks. I should have looked at the FAQ. Didn't think of it. Sorry for wasting your time.
Now to try this baby out
I sure hope it works with my Highpoint 2310 SATA card...
Now to try this baby out
I sure hope it works with my Highpoint 2310 SATA card...