Hi ppl.
I have Nas4Free HAST cluster embedded install with two nodes for example nas1 and nas2. nas1 is a primary node.
I upgraded nas2 from 9.1.0.1 rev 847 to 9.2.0.1 rev 943. After update, in disk management i can't see anymore HAST devices instead there is a warning message: "The Devices in config are different to actual devices. Please remove the devices and re-add it...." and two of my HAST devices are missing. When i am trying to add disks i don't see HAST devices at all... ;(
Same happens if i making nas2 primary node.
What i am doing wrong ?
Thanks.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Problems with HAST after upgrade.
-
omega
- NewUser
- Posts: 3
- Joined: 19 Mar 2014 13:13
- Status: Offline