Hello,
today I upgraded my NAS4free server; I did backup of my configuration, I did a fresh install of the new version and I restored configuration.
Next I did "Clear config and Import disks".
I tested the NAS and all seems OK, but in the Status|Disk the "file system" column of the Mirror1 device is "Unknown or unformatted" (the Status is COMPLETE); in the previous version was "UFS"
In the Disks|Mount Point|Management the Mirror1 File system is ufs.
Is it a problem?
If yes, what can I make to resolve?
Thanks in advance.
P.S. I'm sorry for my little english
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Upgrade 9.1.0.1 to 9.2.0.1 (972)
-
zioarvi
- NewUser
- Posts: 1
- Joined: 02 Sep 2014 12:14
- Status: Offline
-
F8BOE
- experienced User
- Posts: 106
- Joined: 03 Jun 2013 23:09
- Location: France
- Status: Offline
Re: Upgrade 9.1.0.1 to 9.2.0.1 (972)
Hello,
If you backed up your configuration file and restored it after upgrade, why did you clear your HDD config? Wasn't it good? Were there errors?
If you clear all disks and import them all, you'll have to do the job to the end and configure them in order to mount them in the end...
If the disks appear in the status page as they did before upgrade, there's no problem. But if they are mismatched you'll have to reallocate them carefully.
Ciao @+
If you backed up your configuration file and restored it after upgrade, why did you clear your HDD config? Wasn't it good? Were there errors?
If you clear all disks and import them all, you'll have to do the job to the end and configure them in order to mount them in the end...
If the disks appear in the status page as they did before upgrade, there's no problem. But if they are mismatched you'll have to reallocate them carefully.
Ciao @+