Today I've tried to setup a "single run" job to transfer a huge amount of data from a QNAP device to a brand new N4F microserver.
Any activation of the replication job proved to be unsuccessful. The Rsync Server log reported "error in protocol data stream". Don't know what is the Rsync version in use on the Qnap.
After some research I found that the 3.1.0 Rsync release (N4F stable) is affected by a bug that might cause this issue.
So I downloaded the brand new N4F Alpha version and the job has been able to start without any Issue (after having understood that I had to specify UID and GUID on the Module to prevent Authorization issues).
Hope useful
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
(SOLVED) Qnap to N4F: Rsync 3.1.0 bug
-
klo
- NewUser
- Posts: 10
- Joined: 06 Nov 2014 23:12
- Status: Offline
-
zoon01
- Developer
- Posts: 724
- Joined: 20 Jun 2012 21:06
- Location: Netherlands
- Contact:
- Status: Offline
Re: Qnap to N4F: Rsync 3.1.0 bug
Fixed in 3.1.1
Regards,
zoon01
Regards,
zoon01
System specs: XigmaNAS 11.2.0.4 -embedded on Samsung 860 EVO 256GB and Supermicro X10SL7-F w / Bios v3.2, IPMI v.03.86 / CPU E3-1241 v3 @ 3.50GHz - 32GB Crucial DDR3L 1600mhz ECC 1.35v , LSI 2308 on PH20.00.07.00 IT mode, Storage: 5x Western Digital Red (WD30EFRX) raidz
Development system is same system in virtualbox.
Development system is same system in virtualbox.