Hi all,
I was trying to upgrade from .959 to .972. I tried 2 CD burns. fast and slow, and both hung on opensolaris.so from a clean CD boot. System is in my sig. I was trying to upgrade from the a CD boot for a full upgrade.
System boots fine from the drive.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Hang on .959 to .972
-
paulg
- Starter
- Posts: 22
- Joined: 24 Jun 2012 00:50
- Location: Albuquerque
- Status: Offline
Hang on .959 to .972
NAS-less for the moment
-
b0ssman
- Forum Moderator
- Posts: 2438
- Joined: 14 Feb 2013 08:34
- Location: Munich, Germany
- Status: Offline
Re: Hang on .959 to .972
how long did you wait? it might take up to 5 min for that stage on broken bios implemenmtations
Nas4Free 11.1.0.4.4517. Supermicro X10SLL-F, 16gb ECC, i3 4130, IBM M1015 with IT firmware. 4x 3tb WD Red, 4x 2TB Samsung F4, both GEOM AES 256 encrypted.
-
paulg
- Starter
- Posts: 22
- Joined: 24 Jun 2012 00:50
- Location: Albuquerque
- Status: Offline
Re: Hang on .959 to .972
That was it, I was not waiting the FIVE minutes!
At the end of the upgrade (option 5), it said it could not find an existing configuration. I rebooted and it seems ok but a little disconcerting.
At the end of the upgrade (option 5), it said it could not find an existing configuration. I rebooted and it seems ok but a little disconcerting.
NAS-less for the moment