Hi Folks,
I must use CLI to set DNS, the GUI doen't support this?
When I use DHCP DNS settings are good. Using a fixed IP the gateway can be set DNS not!
Please advice,
Eric
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
How to set DNS by GUI? CLI works fine but...
-
eric2009
- NewUser
- Posts: 1
- Joined: 23 Jun 2012 20:43
- Location: Capelle a/d IJssel, Nederland
- Status: Offline
-
raulfg3
- Site Admin
- Posts: 4865
- Joined: 22 Jun 2012 22:13
- Location: Madrid (ESPAÑA)
- Contact:
- Status: Offline
Re: How to set DNS by GUI? CLI works fine but...
General | option ( first menu in the left) DNS do not configure in LAN , config is in general.
12.1.0.4 - Ingva (revision 7743) on SUPERMICRO X8SIL-F 8GB of ECC RAM, 11x3TB disk in 1 vdev = Vpool = 32TB Raw size , so 29TB usable size (I Have other NAS as Backup)
Wiki
Last changes
HP T510
Wiki
Last changes
HP T510