After installing thebrig and starting a jail i can no longer access the web gui for nas4free 9.3.0.2.1190.
Any ideas how to get it back?
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
lost web gui after installing thebrig
-
krpepe
- NewUser
- Posts: 2
- Joined: 13 Nov 2014 17:47
- Status: Offline
-
MikeMac
- Forum Moderator
- Posts: 429
- Joined: 07 Oct 2012 23:12
- Location: Moscow, Russia
- Contact:
- Status: Offline
Re: lost web gui after installing thebrig
Something goes wrong. I had the same done - everytning works fine.
1) Become sure your jail use different IP then your NAS.
ping both
2) Make sure if your problem is due to jail
Try to stop your jail. I hope you have ssh active - connect and stop jail.
If no ssh - try to reboot NAS. I hope you use UPS and nut active. Just disconnect UPS from electricity and nut will stop NAS in according with your settings.
1) Become sure your jail use different IP then your NAS.
ping both
2) Make sure if your problem is due to jail
Try to stop your jail. I hope you have ssh active - connect and stop jail.
If no ssh - try to reboot NAS. I hope you use UPS and nut active. Just disconnect UPS from electricity and nut will stop NAS in according with your settings.
-
romanov.df
- NewUser
- Posts: 11
- Joined: 22 Jul 2012 20:58
- Location: Moscow
- Contact:
- Status: Offline
-
MikeMac
- Forum Moderator
- Posts: 429
- Joined: 07 Oct 2012 23:12
- Location: Moscow, Russia
- Contact:
- Status: Offline
Re: lost web gui after installing thebrig
topic starter had mentioned v 9.3romanov.df wrote:Try viewtopic.php?p=7348#p7348
This version used pkgng instead of pkg_* and this old topic is not applicable, at least without tuning