Ok,
So I've been using nas for about a year now. I had to tear down the server a while back and just getting it back up. The embedded system really is the way to go. Anyway, I have a USB drive that is already formatted to USF. When I plug it in it shows up as a physical drive OK. But when I go to mount it I get the following errors.
You can't mount the partition '/dev/da0a' where the config file is stored. This shows up on the bottom of the page. Sorry, but I don't choose the mount point, so I don't understand the message.
When I press add I get the following errors
The following input errors were detected:
Wrong partition type or partition number.
/dev/da1s1: Can't get UFS ID.
dumpfs: /dev/da1s1: could not find special device
I can mount this drive manually by ssh to the server and running the normal mount command. It mounts fine and I can read and see all the files. I would really appreciate any help on what is going on there.
Thanks.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!