Did as you stated and that worked perfectly. Cleared and Imported disks and then cleared and imported software raid.
Thank you.
This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Problem (bug ?) with disk management
-
diablos666
- NewUser
- Posts: 7
- Joined: 29 Sep 2012 02:13
- Status: Offline
-
ghelfrich919
- NewUser
- Posts: 9
- Joined: 16 Jul 2012 01:40
- Status: Offline
Re: Problem (bug ?) with disk management
I have not seen any posts on this issue in awhile. I wait a couple of release and install and try again to see if this issue has been resolved. But so far, disk management behavior is the same with additional disks causing a reordering of the disks. Possibly I have mis-read this thread and this has been fixed or resolved in a different and I have just not realized it yet - or it is a feature I don't fully understand or appreciate or know how to use correctly without issue.
Does anyone had any further insight into this issue? Thanks
Does anyone had any further insight into this issue? Thanks
-
encryptedbytes
- Status: Offline
Re: Problem (bug ?) with disk management
daoyama wrote:If you use Software RAID, you must run both "clear and import disks" and "clear and import raid disks".
This update all member of RAID, and update mount point depend on the array and individual disks.
This worked for me too, thanks!diablos666 wrote:Did as you stated and that worked perfectly. Cleared and Imported disks and then cleared and imported software raid.
As of 9.1.0.1 - Sandstorm (revision 636), Disk Management still has this behavior.ghelfrich919 wrote:...so far, disk management behavior is the same with additional disks causing a reordering of the disks. Possibly I have mis-read this thread and this has been fixed or resolved in a different and I have just not realized it yet - or it is a feature I don't fully understand or appreciate or know how to use correctly without issue.