This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Log doesn't prompt for errors
-
sb00nk
- experienced User
- Posts: 79
- Joined: 16 Jul 2013 23:55
- Status: Offline
Log doesn't prompt for errors
I've started the execution of rsync when the secondary host was offline (fake run in the image) than i've do the same test with the secondary host online (real run in the image) here are the logs provided by the Diagnostic tab in the web gui
for me it's impossible to know if the sync was successful reading those logs and it's a real problem because i use this procedure for saving offsite the most critical data, i need to know if they are up to date or not
You do not have the required permissions to view the files attached to this post.
Code: Select all
NASSERVER
firmware: 11.1.0.4 - Atomics (revision 4528)
setup: x64-embedded on 16GB microSD (Samsung MB-MP16D/EU)
case: Cooler Master Silencio 550
mb: ASROCK C2550D4I
cpu: Intel Avoton C2550 @ 2.40GHz
ram: 32GB DDR3 ECC (4x Kingston KVR16E11/8)
hds: 4x2TB RaidZ (WD20EFRX)
cold spare: 1x WD20EFRX
BACKUP
NETGEAR ReadyNAS Duo
hds: 2x500GB Raid1 (WD5000AADS)
cold spare: 1x WD5000AADS
-
Lee Sharp
- Advanced User
- Posts: 251
- Joined: 13 May 2013 21:12
- Contact:
- Status: Offline
Re: Log doesn't prompt for errors
If you look in the rsync section you will see that it does not seem to be getting a lot of attention. Most howtos are about using rsync from the command line, or from a different full server, as opposed to using the web GUI. I do not think rsync from the web GUI is a high priority.