IP address unreachable

[alexey123]

print to forum output command

Code: Select all

pciconf -lve

You may execute from webgui Advanced|Execute command

[Alice]

I am away from the computer at the moment. I will do the output command
when I am back the week after next.
I was also wondering if the following link I found could be used in my case?
http://www.freebsdwiki.net/index.php/Ne ... 28basic%29

[Alice]

alexey123, here is the printout. I should also mention that this is a UEFI motherboard which may be the cause of all the problems I am having.

Many thanks.

Code: Select all

$ pciconf -lve
hostb0@pci0:0:0:0:	class=0x060000 card=0x50001458 chip=0x0c008086 rev=0x06 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = bridge
    subclass   = HOST-PCI
    PCI errors = Received Master-Abort
vgapci0@pci0:0:2:0:	class=0x030000 card=0xd0001458 chip=0x04128086 rev=0x06 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = display
    subclass   = VGA
hdac0@pci0:0:3:0:	class=0x040300 card=0x20108086 chip=0x0c0c8086 rev=0x06 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = multimedia
    subclass   = HDA
xhci0@pci0:0:20:0:	class=0x0c0330 card=0x50071458 chip=0x8c318086 rev=0x05 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = serial bus
    subclass   = USB
none0@pci0:0:22:0:	class=0x078000 card=0x1c3a1458 chip=0x8c3a8086 rev=0x04 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = simple comms
ehci0@pci0:0:26:0:	class=0x0c0320 card=0x50061458 chip=0x8c2d8086 rev=0x05 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = serial bus
    subclass   = USB
hdac1@pci0:0:27:0:	class=0x040300 card=0xa0021458 chip=0x8c208086 rev=0x05 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = multimedia
    subclass   = HDA
pcib1@pci0:0:28:0:	class=0x060400 card=0x50011458 chip=0x8c108086 rev=0xd5 hdr=0x01
    vendor     = 'Intel Corporation'
    class      = bridge
    subclass   = PCI-PCI
pcib2@pci0:0:28:2:	class=0x060400 card=0x50011458 chip=0x8c148086 rev=0xd5 hdr=0x01
    vendor     = 'Intel Corporation'
    class      = bridge
    subclass   = PCI-PCI
pcib3@pci0:0:28:4:	class=0x060400 card=0x50011458 chip=0x8c188086 rev=0xd5 hdr=0x01
    vendor     = 'Intel Corporation'
    class      = bridge
    subclass   = PCI-PCI
ehci1@pci0:0:29:0:	class=0x0c0320 card=0x50061458 chip=0x8c268086 rev=0x05 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = serial bus
    subclass   = USB
isab0@pci0:0:31:0:	class=0x060100 card=0x50011458 chip=0x8c5c8086 rev=0x05 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = bridge
    subclass   = PCI-ISA
ahci0@pci0:0:31:2:	class=0x010601 card=0xb0051458 chip=0x8c028086 rev=0x05 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = mass storage
    subclass   = SATA
none1@pci0:0:31:3:	class=0x0c0500 card=0x50011458 chip=0x8c228086 rev=0x05 hdr=0x00
    vendor     = 'Intel Corporation'
    class      = serial bus
    subclass   = SMBus
re0@pci0:2:0:0:	class=0x020000 card=0xe0001458 chip=0x816810ec rev=0x06 hdr=0x00
    vendor     = 'Realtek Semiconductor Co., Ltd.'
    device     = 'RTL8111/8168B PCI Express Gigabit Ethernet controller'
    class      = network
    subclass   = ethernet
     Corrected = Advisory Non-Fatal Error
em0@pci0:3:0:0:	class=0x020000 card=0xa01f8086 chip=0x10d38086 rev=0x00 hdr=0x00
    vendor     = 'Intel Corporation'
    device     = '82574L Gigabit Network Connection'
    class      = network
    subclass   = ethernet

[Alice]

alexey123,
I found the problem - I went into BIOS for the umpteenth time and found that ERP was disabled.
I enabled it and it worked. I'll test it again tomorrow.
For now I hope this will help someone who will have the same problem.

[Alice]

alexey123,

I apologize very much. On further testing, I found that it was not ErP. It was the Network Stack in the BIOS which I disabled and it works with both ErP disabled or enabled. I forgot that I disabled Network Stack at the same time as I enabled ErP. Sorry about that.