(SOLVED) Error: The changes could not be applied (error code 1)

cssine · Post by **cssine** » 25 May 2015 18:22

Just upgraded to 9.3.0.2 (Embedded). Existing shares seem to work fine, but can't create a new one. I get Error: The changes could not be applied (error code 1).

Checked the system log and found "root: Failed to reload service samba". Any ideas?

Thanks

Post by **raulfg3** » 25 May 2015 20:46

you can't upgrade from 9.1 to 9.3, you need to install and configure grom scratch ( of course your data are safe, only need to configure CIFS by hand).

Please do not crosspost: viewtopic.php?f=15&t=8954

cssine · Post by **cssine** » 25 May 2015 21:35

I did install from scratch (I restored the config backup from 9.1). I'll try the reset to factory and manually recreate the shares.

Thanks

cssine · Post by **cssine** » 25 May 2015 22:17

Skipped the restore config and things went much smoother. I was sure I read that a config restore was required .. but nope!

Thanks again for the help. That fixed it.

XigmaNAS

(SOLVED) Error: The changes could not be applied (error code 1)

(SOLVED) Error: The changes could not be applied (error code 1)

Re: Error: The changes could not be applied (error code 1)

Re: Error: The changes could not be applied (error code 1)

Re: Error: The changes could not be applied (error code 1)