This is the old XigmaNAS forum in read only mode,
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
it will taken offline by the end of march 2021!
I like to aks Users and Admins to rewrite/take over important post from here into the new fresh main forum!
Its not possible for us to export from here and import it to the main forum!
Upgrade from 943
-
cornelis
- NewUser
- Posts: 1
- Joined: 24 Jul 2015 22:48
- Status: Offline
Upgrade from 943
I have been running FreeNas and later Nas4free for som time. I want to upgrade from 943 to 1731. Problem is this live cd needs 2 Gbyte of Ram, and I only have 512 Mbyte (Via Epia SN1800G, 512 Mbyte ram, boot from Transcend 8Gbyte CF, hard drive Seagate Baracuda 7200.12 1 Tbyte). How can I upgrade without upgrading my hardware?
-
b0ssman
- Forum Moderator
- Posts: 2438
- Joined: 14 Feb 2013 08:34
- Location: Munich, Germany
- Status: Offline
Re: Upgrade from 943
where did you see a 2gb ram requirement? its 2gb storage.
Code: Select all
Requirements
============
Embedded: 2GB CF/USB/SSD (NAS4free "Embedded" is Recommended Install)
Full: 4GB HDD/SSD (For developers and some advanced users, Not Recommended!)
Swap less: physical memory 2GB or higher needed.
With swap: physical memory 512MB + swap 512MB (swap 1024MB recommended).
*Note: LiveCD is not supported on swap mode except installation and upgrading.Nas4Free 11.1.0.4.4517. Supermicro X10SLL-F, 16gb ECC, i3 4130, IBM M1015 with IT firmware. 4x 3tb WD Red, 4x 2TB Samsung F4, both GEOM AES 256 encrypted.